Galvanised key clamp fittings and handrails in malleable iron — elbows, tees, flanges and bases in sizes A to E (26.9–60.3mm), joined with an Allen key and no welding.
























Galvanised Key Clamp Fittings & Handrails
Galvanised key clamp fittings join steel tube into handrails, guardrails and frames with nothing more than an Allen key — no welding, no drilling, no hot works permit. Every fitting in this collection is cast in malleable iron and hot-dip galvanised, so the handrail can go straight outdoors and resist rust for decades. It is the same mechanical system as our full key clamps range, supplied here specifically in the galvanised finish for exposed and external work.
What is in the range
Over 500 fittings cover every joint a handrail needs: 90° elbows to turn a corner, short and long tees to run a mid-rail into an upright, three-way and four-way crosses, wall and oval base flanges to fix down, swivel connectors for raking stair rails, and internal tube joints to extend a straight run. Each fitting grips the tube on grub screws tightened to 39Nm, and each screw gives an estimated axial holding load of up to 900kg — strong enough for a load-bearing guardrail, not just a decorative rail.
Sizes — match the fitting to the tube
Fittings are made to five tube sizes, A to E, and a fitting only works with its own size. Size C (42.4mm) is the common handrail diameter, stocked as our 42mm key clamp fittings, with the heavier D (48.3mm) and E (60.3mm) sizes carrying guardrail and structural rails. The full size table is:
- Size A — 26.9mm OD — 20mm nominal bore (¾")
- Size B — 33.7mm OD — 25mm nominal bore (1")
- Size C — 42.4mm OD — 32mm nominal bore (1¼"), the common handrail size
- Size D — 48.3mm OD — 40mm nominal bore (1½"), heavy guardrail
- Size E — 60.3mm OD — 50mm nominal bore (2"), the heaviest structural rails
If you are unsure, measure the outside diameter of your tube and match it to the figure above, not to the nominal bore.
Building a handrail
For a complete handrail you need fittings, tube and feet. Matching galvanised steel pipe is stocked in every size from A to E and cut to length, so the rail and its fittings share one diameter and finish from end to end. For the standard rail layouts worked out ready to order — mid-rail, top-rail and raking stair sections — see our key clamp handrails & railings collection.
